Builders' Forum Archives |
Re: Bulkhead radius good
Posted by Laszlo on Oct 26, 2004
Lee,
Thanks for the memory jog. That picture and the fact that the plywood has to be tortured to bend in multiple directions (and loses much of its stiffness as a result) is where I got the idea that the pipe test was valid.
I like that idea of planing to a chord - it would give a lot more bearing area as well as reducing epoxy consumption for filling the gap.
Thanks,
Laszlo
In Response to: Re: Bulkhead radius good by LeeG on Oct 26, 2004
Replies:
- Re: Bulkhead radius good by M Davis on Oct 26, 2004
- Re: Bulkhead radius good by LeeG on Oct 26, 2004
- Re: Bulkhead radius good by Laszlo on Oct 27, 2004