Re: Bulkhead radius bad?

Posted by Peter on Oct 24, 2004

Hey Lazlo,

I just finished my wife's 16 LT and she really loves it.

I had the same problem with my bulkhead radius and had to do some filling after the deck was on. I did notice the problem while I was planing the sheer clamps and couldn't really make any adjustments at that time as it would make the bulkhear radius to low and the deck wouldn,t contact it at all. Turned out that the deck just contacted the radius of the bulkhead at the center. I wound up filling the gap with epoxie and wood flour. I to wonder why the bulkhead is off. It didn't fit the hull well either. Probably should contact CLC with this question.

Peter

In Response to: Bulkhead radius bad? by Laszlo on Oct 24, 2004

Replies:

No Replies.