Builders' Forum Archives |
Where to buy copper wire?
Posted by jahrome on Sep 21, 2004
I am having the same problem with my Chesapeake 17. I started stitching the hull and side panels and worked my way back and was off at the end by a little over a 1/4". Well, I'm going to just redo the stiching since I started out tightening everything too much. There are some bumps and hollows I need to work out in the hull as well. It's not terrible, I imagine it could be done much worse, just not good enough!
My question is who carries 18 gauge copper wire?
In Response to: Re: wiring together MC 13 by Steve Miller on Sep 19, 2004
Replies:
- Re: Where to buy copper w by Larry on Sep 21, 2004
- Re: Where to buy copper w by jahrome on Sep 22, 2004
- by on
- Re: Where to buy copper w by RogerJ on Sep 22, 2004
-
Re: Bar magnets by David on Jan 6, 2005
- Re: Bar magnets by RogerJ on Jan 6, 2005
- Re: Bar magnets by Jay E Morris on Jan 6, 2005
- Re: Bar magnets by terry on Jan 6, 2005
- Re: Bar magnets by Mike Delchambre on Jan 6, 2005
- Re: Rare Earth Magnets by Dave Houser on Jan 6, 2005
- Re: Rare Earth Magnets by terry on Jan 6, 2005
- Re: Rare Earth Magnets by Dave Houser on Jan 6, 2005
- Re: Bar magnets by Mike Delchambre on Jan 6, 2005
- Re: Bar magnets by mike noeske on Jan 6, 2005
- Another link.... by Ken Leffert on Jan 6, 2005
- Re: Bar magnets by RogerJ on Jan 6, 2005
-
Re: Bar magnets by David on Jan 6, 2005