Builders' Forum Archives |
protruding wires
Posted by Peter on Jul 20, 2004
I just flipped my hull over and started snipping wires. What's the best way to get rid of that little bit that is protruding? I did some with my block plane but am a little concerned about making a gouge if Im not careful.
Replies:
- Re: protruding wires by Kurt Maurer on Jul 20, 2004
- Re: protruding wires by Doug Judd on Jul 20, 2004
- I snip one side, heat by Charlie Jones on Jul 20, 2004
-
Re: I snip one side, heat by Kurt Maurer on Jul 20, 2004
- Re: I snip one side, heat by LeeL on Jul 20, 2004
- Tabbing between wires by Jay E. Morris on Jul 20, 2004
- Re: Tabbing between wires by Archie M. Sullivan on Jul 20, 2004
- Re: wires & tabs by BobE on Jul 20, 2004
- Re: wires & tabs by Jay E. Morris on Jul 21, 2004
- Tabbing between wires by Jay E. Morris on Jul 20, 2004
- Takes about 10 seconds by Charlie Jones on Jul 20, 2004
- Re: Takes about 10 second by Jon T on Jul 21, 2004
- I think it's a 250-450 by Charlie Jones on Jul 22, 2004
- Re: Takes about 10 second by Jon T on Jul 21, 2004
- Re: I snip one side, heat by FrankP on Jul 21, 2004
- Re: I snip one side, heat by LeeL on Jul 20, 2004
-
Re: I snip one side, heat by Kurt Maurer on Jul 20, 2004
- Re: protruding wires by Mark Camp on Jul 20, 2004
-
Okay. Hmmm... by Kurt Maurer on Jul 21, 2004
- Re: Okay. Hmmm... by RogerJ on Jul 21, 2004
- Re: Okay. Hmmm... by Mark Camp on Jul 21, 2004
-
Re: protruding wires by Terry Mcadams on Jul 22, 2004
- Re: protruding wires by Laszlo on Jul 22, 2004
- Re: protruding wires by Terry Mcadams on Jul 22, 2004
- Re: protruding wires by Laszlo on Jul 22, 2004
-
Okay. Hmmm... by Kurt Maurer on Jul 21, 2004
- Re: protruding wires by David Gostanian on Jul 24, 2004