Re: epoxy "bubbles"

Posted by Steve Miller on May 24, 2004

Did you tip off your coating? If you brush or esp if you roll then you need to come back in a while to tip off the bubbles. I like to wait about 20 minutes in my shop. Sort of a job specific timing thing but just don't wait too long. I use a clean foam brush to tip. One direction only, no back and forth.

Some of the bubbles are there from mixing too. These should mostly tip out.

In Response to: Re: epoxy "bubbles" by RayA on May 24, 2004

Replies:



 

Fall Kit Sale 2016