RE: Countersinking brass rub strips

 » Submitted by lafisher - Fri, November 6 » 10:45 PM

Laszlo;

 I have used router bits made of the same material to chuck into a drill press and machine solid blocks of brass to make a handplane. Granted the milling passes were very shallow, but the router bit was no worse for wear when I was done. So, the answer would be an unequivical yes for using those bits on brass.

RE: Countersinking brass rub strips

 » Submitted by Laszlo - Sun, November 8 » 6:41 AM

Thanks la,

Picked up my set on your  recommendation yesterday,

Laszlo